For moisture-resistant hard floors, such as suitable PVC, vinyl, laminate and tiles. These instructions apply to the liquid Flacon A, not to pods or other James cleaners.
Care task 1
Daily cleaning
Use James Floor Cleaner Clean & Dry Fast for general dirt.
- Remove dust and sand.
- Mix 50 ml with 8–10 liters of water.
- Damp-mop the floor. Rinse the dirty mop occasionally in a separate bucket of clean water.
- Allow the floor to dry thoroughly. Use as little water as possible on moisture-sensitive areas.
Care task 2
If a regular mopping isn't enough
Stubborn dirt or built-up residue may require a separate basic cleaning. For this, James recommends Basic Cleaner, with its own dosage and application method. A higher dose of Clean & Dry Fast is not an automatic alternative.
Are you using a robot mop? Also check whether the manufacturer of the device allows this product in the reservoir. Do not simply apply the bucket dosage to any automatic dosing system.
Care task 3
Pods and protective layers
Use one James Pod per 8–10 litres of water during your regular mopping. The liquid Flacon A has its own dosage.
To apply a new protective layer, first assess the floor. Use Basisreiniger according to the instructions before application. Then, only if suitable, choose Extra Mat or Zijdemat.
Sources and product versions
Manufacturer information checked on 2 November 2026. Also check the label of your specific product. Drying times are guidelines; temperature, humidity and ventilation affect the result.
Dosage and steps also checked in the current James product information from May 2025. The PDF copy itself is the earlier available manufacturer version with the same manual dosage; the current page is listed below under the source attribution.